Berko - ConVector HeatersBerko website

 

Commercial Slope Top Convectors (ST)

  Provides total or
   supplemental heating for
   offices, corridors, lobbies,
   motels, apartments or
   similar facilities

  Prevents cold down drafts
   when mounted under expanses of glass

  With a range of heating capacities from 125 watts (426 BTU per
   hour) to 250 watts (852 BTU per hour) per foot length, these units
   can run from wall-to-wall or they can be mounted as discrete units
   in lengths of 28-inches to 10 feet

  The attractive 45° sloped top discourages use of heater as a shelf
   or a "step stool"

  The unit is designed to mount on the wall at sill height (or lower)
   and can be positioned directly on the floor

  The end of the unit can be positioned against adjacent sidewall if
   desired

  Standard finish is neutral grey (also available in a spectrum of muted
   architectural colors in baked enamel finishes which are compatible
   with all interior decors)

  Front cover is fabricated from 16-gauge steel, back cover is
   constructed of 18-gauge steel

  For service, all internal parts are accessible by removing cover
   (top of front cover engages with back; bottom of cover locks into
   place with screws)

  Elements are long life metal sheath, aluminum fin type anchored to
   allow for quiet expansion and contraction

  Thermal limit switch with linear type (full length) sensing bulb
   provides constant protection against overheating from any cause
   (switch automatically resets when normal operating temperatures
   are restored)

  Units are prewired. Units without optional controls are designed for
   either right hand or left hand entry for easy connection of supply
   wiring from bottom, rear or end, as well multiple wiring of adjacent
   heaters from one entry point.

  Accessories include a complete line of matching splice sections,
  inside and outside corners

  Optional built-in controls consist of: thermostat, disconnect switch,
   transformer relay and power relay

  Available in 120, 208, 240, 277, 347 and 600 volts and 500, 750,
   1000, 1250, 1500, 2000 and 2500 watts

 

Stainless Steel, NEMA 4X Models Available

  NEMA 4X rated for washdown and corrosive applications

  The NEMA 4X series slope top convectors specifically designed for
   use in wet or corrosive environments like those found in food
   processing areas, dairies, breweries, locker rooms, stadium dugouts,
   and other areas that are subject to high pressure hosing and/or
   constantly wet conditions. Suitable for use in areas where severe
   corrosion problems exist from either salt spray or chemical exposure
   such as a sewage treatment plant or indoor swimming pool.

  Rugged 16-gauge stainless steel front and back covers

  250 watts per foot

  Automatic thermal cutout

  Note: Optional built-in controls are not compatible with the
   NEMA 4X series of slope top convectors

 

 

Berko has several products. Only selected products are featured here. For information on additional Berko products please check Berko's website or request information from ESA.