Berko Washdown/Explosion Proof HeatersBerko's website

 

Explosion Proof Unit Heater (RUX)

  Designed to heat areas
   classified as hazardous
   locations designated as
   Class I, Group C & D
   Division 1 & 2 or Class II,
   Groups E, F and G with a
   T3B ignition temperature
   code rating (329ºF,
   165ºC) or higher to
   provide primary or
   supplementary heating
   for comfort or freeze
   protection

  Typical applications involve oil refineries, sewage treatment plants,
   petrochemical plants, oil rigs, unattended pumping stations, chemical storage
   and handling facilities, paint storage areas and more

  Pre-wired, self-contained control center

  Standard controls include automatic reset thermal limit, a magnetic contactor
   and 24 volt control circuit transformer

  Advanced design allows lower operating temperatures from the liquid to air
   heat exchanger with steel tubes, aluminum fins, a non-toxic heat transfer fluid
   and a pressure relief plug

  Includes a factory built-in thermostat, disconnect switch, fan selector switch,
   120V control circuit and pilot light

  A manual reset high limit cutout unit is standard (an additional automatic reset
   high limit cutout is available as an option)

  Ball bearing permanently lubricated explosion proof motor has built-in thermal
   overload protection

  Powder coated heavy gauge steel cabinet surrounding a 14
   gauge heavy-duty steel frame which supports internal components

  Available in 208, 240, 480 and 600 volts
   and 3, 5, 7.5, 10, 15, 20, 25 and 30 watts

 

Berko has several products. Only selected products are featured here. For information on additional Berko products please check Berko's website or request information from ESA.